Kevin,
Please re-check.
The pin numbers are not marked on the board or on the module.
According to the voltage chart, pin 1 is the output pin and pin 4 is
closest to U6.
If you have 13.6 volts on pin 3, you have a error somewhere - that pin
is fed from the output of the 5 volt regulator U3.
73,
Don W3FPR
On 10/10/2013 12:44 PM, NZ1I wrote:
> Hi Folks,
>
> I have a XV 50 that has no output. Nothing is showing on my Bird meter but
> the LEDS do light up across the front of the transverter when I whistle into
> the mic. It appears to receive ok.
>
> Measurements taken:
> U7 Pin 2- 13.6v receive, Pin 3- 13.6v ( should be 3.5 - 4.5) transmit
>
> U 3 Input - 0v receive( ok), 13.5v transmit( within limits?)
> Output- 0v receive (ok), 9v transmit ( should be 5v)
>
> U 6 Output- 0v receive(ok), 1.7v transmit ( to K2 relay) and (5v to Z3)
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html