Hi all:
OK, I solved the problem with no voltage at TP5.
Now, in trying to align the XV50, being driven by my K2, I note the
following:
1. The attempts to peak L12,13,14,15,16 and L17 are hampered by the fact
that if I drive the XV50 for more than a few seconds, the peak voltage
measured at TP5 begins to decline. When I let the thing cool off, the
voltages go back to where they were. Is this normal behavior? It is very
hard to be sure I have them peaked.
2. With 5 watts out from the K2, I cannot get output power of more than 15
watts from the XV50. Any suggestions on this?
Tnx de Brian W3BW
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
