Hi all:
I am performing the alignment step that involves peaking the voltage at TP5
by adjusting L12, L13 ... L17. I find that the voltage starts to decline a
few seconds after I first key my K2. After I allow a few seconds of "cool
down", the voltage recovers, but this behavior makes it almost impossible to
tell if I have peaked the inductors properly.
I also have found that I cannot get more than 15 watts output from the XV50
when driven by 5 watts from the K2.
Any suggestions for how to proceed would be greatly appreciated.
73 de Brian W3BW
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
