Hi
I had the same problem with my K2 as Tom KG3V did with his speaker
wire. Only my mistake was with the volt meter probe. I was plugging
it into P6 on the wrong board.
Why would Elecraft put connectors with the same number on several
different boards. I don't think they would run out of numbers if they
used consective numbers from start to finish on all the boards.
Of course if you pay attention when reading the instructions it
wouldn't be a problem, but who does?
My two cents worth!
Scott N5SM
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
