Nick,
R18 and R19 are zero ohm resistors - in other words 'jumpers'.
The jumpers will be removed if you install the KAF2 or the KDSP2 option
and the holes where the jumpers are located will be used for mounting
the headers - so consider whether to solder the jumpers on the top or
bottom of the board with thoughts of removing them later.
If you already have the KAF2 or KDSP2 option, consider just installing
the headers and using component leads inserted into the headers to
complete the audio circuit path until you have constructed the option.
73,
Don W3FPR
Nick T wrote:
> Hi Guys,
>
> I am building k2 kit # 6163. I have a question about installing a
> jumper between R18 and R19.
>
> The way the directions are worded this jumper could go bridge R18 to
> R19 OR simply go on top of the board one on R18 to either side and one
> on R19 to either side.
>
> I assume it is the later, but I want to be sure!
>
> Can anyone enlighten me?
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
