I have been slowly assembling K3 #5642. Progress has been uneventful up
to the point where I am to install the top cover on the basic 10w
version, prior to calibration and testing. The mid-point of the left
side of the top cover does not sit down sufficiently. It appears that
the chassis stiffener is a bit too high on that side (the KPA3 shield
has been installed). I investigated and it appears to me that the
cup-like structure that the screw enters on the left end of the
stiffener is vertically misplaced, causing that end of the stiffener to
be too high for the top cover. The stiffener does not appear to be bent
in any way. Everything else has fit perfectly. I would appreciate any
suggestions.
73, Dave K1YHR.
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
