found reciever problem, but now something else

[Roland Whitsitt]

Thanks Don and others,
  Seems to have been a cold solder joint AGAIN!  In the area of L1 and L2.  I think it was c5 but not sure.  I re-touched all of it and it came to life!  Yeaaaa!
Now as I listen to the qso's, I noticed when I tune a little, there is a fluttery sound (almost an echo but not quite) everytime I move the vfo knob.  Is this normal at this point.  The sound is a distortion of the voices.  Makes it hard to zero in on the voice.
Thanks,
Roland
#3090

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Jim Younce]

That should go away when you run the Cal PLL if it doesn't check to see if
RFC15 is open.  If it is you will see almost a one volt drop across it. and
the resistance when measured with the power off will be very high.

73
Jim K4ZM


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com