Dan,
Yes, the Elecraft MH2 and the MD2 are no longer available. There have been
some comments from Eric that they were persuing replacements, but no time
frame for availablity was mentioned.
I will not make a specific recommendation, but I can give you some 'food for
thought'
One alternative is to use the Kenwood mic configuration, it is very close to
the Elecraft mic configuaration (only a couple pins different and no
resistor on the mic jack).
Icom mics seem to be quite usable and the mic configuration info is in the
KSB2 manual - most do need a resistor from the 5 volt pin to the AF pin at
the mic jack (although some do not).
I sent a post on mic considerations to the reflector yesterday - the subject
line was 'Getting Started on K2', so you may want to review the archives for
that additional info.
73,
Don W3FPR
> -----Original Message-----
>
> I am at the stage in my k2 building experience where I need to
> configure the
> mic jack in the rig. I want to keep the rig all Elecraft but
> unless I read
> the web site wrong, Elecraft no longer offer the one listed in
> the accessory
> page of the building manual. Does anyone have any suggestions or
> experience with
> the other mics they show that can be configured for use?
>
> Any input will be greatly appreciated.
>
> Dan af4lb (previously kf4pob)
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
