jumpers question

[John Wiener]

Hi, everyone.

I am trying to rescuscitate my K2 after some problems with K60XV.

I have decided to re-do alignment procedures.  Reason? I now realize  
my 40M receive behaves differently than other bands even with the  
K60XV removed.
I used the XG2 to cal the S-meter and could not get a reading of S9  
for the 50 uV signal.  I couldn't even hear the 1 uV sig.

So, now I am back to p. 60 of manual and re-doing the 4 MHz  
oscillator cal.
Problem: I can't access TP3 while I have KDSP2 attached.

My question: Where exactly do I place jumpers on J1 and J2 of Control  
Board?

Thanks

John
AB8O
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Gary Hvizdak]

John (AB8O) wrote ...
    I am trying to [resuscitate] my K2 after some problems with K60XV.
Where exactly do I place jumpers on J1 and J2 of Control Board?


Hi John,
    Glad to hear that your K2 is coming back to life.  See
http://www.unpcbs.com/faq/#diagram for the answer to your question and a
whole lot more.

Gary, KI4GGX
K2 #4067

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com