k2/100 low power

classic Classic list List threaded Threaded
2 messages Options
leo
Reply | Threaded
Open this post in threaded view
|

k2/100 low power

leo
 My k2/100 has been working good for about 12 month's. The only problem was when I put the power over 90W I would get a Hi Cur warning so I would keep it down to 90W, might have been a mistake not to fix that. Now everything over about 20W the radio will drop down to about 20 watts. I'm using a dummy load and cal cur is at 3.5 .The problem is on all bands.
 Looking through the E-Mail's I see that diodes D16,D17 1N5711 in the amp might be bad any thoughts will be appreciated. Thanks  Leo
 kg6wni@yahoo.com
Reply | Threaded
Open this post in threaded view
|

Re: k2/100 low power

Don Wilhelm-4
Leo,

Do a quick and easy test - it does require an external wattmeter and a
200+ watt dummy load, so if you do not have one, borrow it for a quick test.
Put the wattmeter between the KPA100 and a dummy load.  Then turn the
power to 5 watts and do a TUNE.  Is the power indicated on the external
wattmeter close to 5 watts or closer to 12 watts.
If it was closer to 5 watts, repeat the same test at 50 watts.  You will
have to hold TUNE and DISPLAY at the same time.  Did the power stabilize
near 50 watts or does it  go up to 120 watts or greater?

If during the first test, you find that the power soars to 12+ watts, do
not bother with the 2nd test,  There is something wrong with the KPA100
wattmeter.  The most likely failure is diodes D16 and D17, but could
also be U5 or U6.  There is also the possibility that there is a problem
with the scaling resistors or the 2N7000 transistors that control the
scaling.

73,
Don W3FPR

On 3/3/2013 12:56 PM, leo wrote:

>   My k2/100 has been working good for about 12 month's. The only problem was
> when I put the power over 90W I would get a Hi Cur warning so I would keep
> it down to 90W, might have been a mistake not to fix that. Now everything
> over about 20W the radio will drop down to about 20 watts. I'm using a dummy
> load and cal cur is at 3.5 .The problem is on all bands.
>   Looking through the E-Mail's I see that diodes D16,D17 1N5711 in the amp
> might be bad any thoughts will be appreciated. Thanks  Leo
>   [hidden email]
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/k2-100-low-power-tp7570671.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html