hello
wonder if any one can advise
have just come up to page 61 elecraft manual
vco alignment
sarted off ok was able to get 6 volt on 80 mtrs at 4000
then the metre shot up to 8 volt moving the vfo dial slightly
restores to the set volts moving the vfo dial again slightly
it shoots up to 8 volts same on all bands when the metre is
at 8 volts there is no adjustment posible at l 30
same on all bands
all caps are correct value been over all relevant soldering again
not sure if it is posible to test varicap diodes dont want to
start removing them dont have replacements
if the volts is set to the correct value and left without moving
any thingit stays at that value
thanks all tom g0lne
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
