k2 Alignment and Test, Part 1

[Dennis Vavra]

I have conducted test. page 42, right column, step 6. Applied power to K2 and Display indicated Info 090. Appendix E says 090 EEPROM test #1 failed.
Please advise.  Dennis Vavra,  AD5LY
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Dennis,

Read a bit further down on the Appendix E page and you will find the first
steps - "Remove the Control Board and inspect U7 and surrounding traces.
Verify that U7 is properly soldered."

73,
Don W3FPR

> -----Original Message-----
>
> I have conducted test. page 42, right column, step 6. Applied
> power to K2 and Display indicated Info 090. Appendix E says 090
> EEPROM test #1 failed.
> Please advise.  Dennis Vavra,  AD5LY
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.16.12/628 - Release Date: 1/15/2007
11:04 AM

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com