k2 Front Panel board Const

[Dennis Vavra]

Install of the encoder Z1, calls for removal of !/8th inch of the four connector pins. I measured these pins,  uncut to be abt 1/4th inch long. This seems pretty short to me.
After cutting pins, how long should they be when I wrap the 4 wires around them.  Dennis Vavra..AD5LY
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Dennis,

Do just what the manual says - it will all work out.  You will cut the pins
about in half.

73,
Don W3FPR

> -----Original Message-----

>
> Install of the encoder Z1, calls for removal of !/8th inch of the
> four connector pins. I measured these pins,  uncut to be abt
> 1/4th inch long. This seems pretty short to me.
> After cutting pins, how long should they be when I wrap the 4
> wires around them.  Dennis Vavra..AD5LY
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.16.10/624 - Release Date: 1/12/2007
2:04 PM

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com