k2 build question

[Ron McMurray-2]

pg # 29 removing masking material , are they talking about the grey overspray
ron, kc0tdj
#4857
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Michael Pfeuffer]

Hi Ron,

The masking material is the pieces of tape, usually green, around each
hole.  I found a sharp "case cutter" edge was necessary to remove it.  You
should have nice, shiny bare metal around the holes on the inside of each
panel.  That will make sure you get good RF shielding.  The rest of the
overspray on the won't hurt anything.

--Mike WQ5C
K2 #4693

At 06:47 PM 4/3/2005, Ron McMurray wrote:

>pg # 29 removing masking material , are they talking about the grey overspray
>ron, kc0tdj
>#4857
>_______________________________________________
>Elecraft mailing list
>Post to: [hidden email]
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com