k3 ALC problem

[erz.gebirge]

My K3, S/N 7834 and has the newest

Softwareupdate. Power calibration with K3 Utility was enforced.No problem!

TX ALC ON. TECH MD OFF. External watt-meter LP100A.

Problem:

Power out adjust on 30 watts.

issue 1- The meter displayed 100 ..140 watts with the first dot.

              Then, the power out goes back to 30 watts. In
approximately 300…500ms.

Issue 2- After first dot no power. After operate the PTT

              power out 100…140 watts, that go back to 30 watts then.

Issue 3- case 2, but power out only after operate PTT 2 ..3 times.

The portrayed cases happen quite frequently, usually after band-change.

Does somebody have an idea?

Juergen

DL2DX

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Don Wilhelm]

The folks at K3support may have some information for you.

73,
Don W3FPR

On 1/31/2017 4:57 AM, erz.gebirge wrote:

> My K3, S/N 7834 and has the newest
>
> Softwareupdate. Power calibration with K3 Utility was enforced.No problem!
>
> TX ALC ON. TECH MD OFF. External watt-meter LP100A.
>
> Problem:
>
> Power out adjust on 30 watts.
>
> issue 1- The meter displayed 100 ..140 watts with the first dot.
>
>              Then, the power out goes back to 30 watts. In approximately
> 300…500ms.
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]