somethings amiss. I just finished the ATU for kx1 #1056 I gone through
all the steps on page #7 when I get to step #11 it states
"Enter TUNE mode MENU and BAND together ( the kx1 will display forward
power, e.g. P4.0 ) adjust C9 for the lowest possible
reading--the null may be sharp. Cancel TUNE mode by tapping any switch
( the kx1 will display SWR, e.g. r1.0)"..
**********************************
Here's the catch when I enter tune my display reads P0.0 in other words
no forward power I check using my Elecraft DL1 voltage is 7.06 approx 3w
on 40m. I also hear it on my station RX. I removed the KXAT1 recheck
the DL1 reading it was consistent.7.06 approx 3w on 40 there was also no
NULL adjusting C9. I reinstalled the ATU checked it again with the same
results. Now when I came out of tune the KX1 it displayed the SWR r1.0..
**********************************
Again I heard the signal in my station RX and the DL1 read 7.06 and it
was slightly warm to the touch power is there but the reading are not.
Any advice is appreciated.
de "rc" kc5wa
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.2.0 - Release Date: 5/27/2005
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
