Hi Group,
Some of you have already given me some advice on this. I have done some experiment.
The K2 (without K60XV) can give a stable RF power output above 0.5 watt. For any setting between 0.1-0.5 by the Power knot, the output is not stable but will be something not exceeding 0.5 watt.
However, when I go to 'TRN' transverter setting in the SEC manual, when I set the maximum power at 0.1watt, the K2 can give a stable RF output lower than 0.5 watt. Any turning of the Power knot will have no effect on the RF output. I do not have an accurate RF power meter for anything lower than 5 watts.
Could any of you do a power measurement for me by setting the TRN OUT at 0.1?
TNX & 73
Johnny Siu VR2XMC
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
