one quick point about MDS readings

[m0bmn]

Hello again

 

Just a quick one, I did the K2 test with the ATU on, I put a 50ohn load on
the radio first and tuned that 1.0:1 ,and then replaced the load with the
XG1.

How do you put the ATU in bypass mode, I looked in the manual but couldn’t
find it.

Cheers

Paul

M0BMN

 

 


--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.14/131 - Release Date: 12/10/2005
 
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[K6TFZ]

"How do you put the ATU in bypass mode, I looked in the manual but  couldn’t
find it."
 
To bypass the KAT2, go to the menu and set either ATU CALP, ATU CALS or  ATU
POUT (depending on what you want the display to read when pressing TUNE,  see
the chart in the manual) - the KAT2 ANT1 and ANT2 jacks can still be  used
and will be switched as normal.
 
If you want the ATU entirely disable, open the top cover and unplug it,  then
use the lower rear panel BNC jack.

(Thanks, Google.)  Geoff, K6TFZ
 
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com