re:160 linerization/infor 232

[Roland Whitsitt]

Okay, You know that is what I thought too.  And I did do a re-CAL PLL on 40.
Thanks guys!
Roland in Stockton
k2 #3090

""Hi Rowland,

Nothing wrong as cal PLL is only done on 40m these days. Should be noted in erata with the 160 kit. If not it is remiss of Elecraft to keep supplying an obsolete instruction sheet.

Regards,
Bob, G3VVT""

""Hello Roland - I think that you only do CAL PLL on 40 meters even when  you
add the 160 meter board.  I could be wrong but that's what I recall.  73 es
gud dxing -- Don N4HH""
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Ron D'Eau Claire-2]

The documentation is correct. Some builders will need to do CAL PLL on 160,
others do it only on 40 meters. It depends upon the version of the firmware
in the K2.

The second item on the errata sheet provided with the manual reads:

"Page 9, first three alignment steps: These three steps are only necessary
if your K2 firmware is older than revision 2.00. (With revision 2.00 and up,
CAL PLL is done only once, and only on 40 meters, so there's no need to do
it when installing the 160 m option.)"

Ron AC7AC



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com