Fern,
* AUTOINF ("Auto Info") menu entry added. (CONFIG menu; TECH MD must be ON.)
This can be used to send band and frequency data to an attached device
such as an antenna
controller via the K3's serial port. The default is NOR, which doesn't
send anything. If you set it to
AUTO 1, any change in the K3's VFO frequency or band will send an "IF"
(info) response at
the K3's present RS232 baud rate. The commands are sent no more than
once per second.
PC software applications can always override the K3's power-up Auto-Info
mode. NOTE:
Some PC software may be incompatible with the AUTO 1 setting of AUTOINF
because
they already control the autoinfo mode.
73
Greg
AB7R
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]]On Behalf Of Fern Rivard
Sent: Sunday, March 23, 2008 5:56 PM
To: Elecraft Reflector
Subject: [Elecraft] re setting of Auto Inf menu
Could someone please help with setting in the conf menu with Auto Inf
which has choice of Nor or Auto 1. What do either choices do and what is
the better setting?
Thanks from Fern
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
