I'm experiencing a similar result with just-completed #4793. Power
displayed at the bottom end of a 2-needle Armitron power meter seems to
agree with expected better than the internal power reading. I've assumed
that the problem is accumulated calibration errors between the K2 ADC
and the external meter, but...??? Consistent with this is the displayed
current which also reads high by about 15% above the high limit.
Bruce, NM5B
Santa Fe, NM
----- Original Message -----
From: "Lloyd Lachow" <
[hidden email]>
To: <
[hidden email]>
Sent: Monday, April 25, 2005 6:02 PM
Subject: [Elecraft] requested v. actual power out
> On 30-80m, with the power set to 5W, I'm getting
> 6-7W, even with the KAT2 installed. These are the
> kinds of readings I saw prior to installing the tuner,
> and I was hoping the ATU would normalize that.
>
> The power out on the higher bands ranges from 5 -
> 5.5 W or so.
>
> On a borrowed K2, for which I built and installed
> an ATU, the power out was typically within 0.1W of
> the requested power.
>
> Maybe related to this, maybe not, is that during
> CALn, the lowest value I could ever get was 007.
>
> LL/ K3ESE K2 #4442
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
