Cris,
In that case, you have firmware 2.04R which locks the sidetone source at
U8-4.
Is your K2 Serial number below 3000? If so you must do the sidetone
source wiring changes as shown in the KIO2 or KPA100 manual.
If SN3000 or above, you have a problem that needs to be found. Do you
have an oscilloscope to aid in troubleshooting?
73,
Don W3FPR
On 7/26/2020 12:18 PM, Christophe aufacf wrote:
> hello sorry for the delay,
> I didn't have the time, look at the lack of time
>
> stl regler 030, I press on display I have U8-4 but impossible to switch to U8-25
>
> thank you for your opinion
>
> thank you again for your precious help
>
> 73 , Cris F8ACF
>
> Le lun. 20 juil. 2020 à 22:56, Don Wilhelm <
[hidden email]> a écrit :
>> Christophe,
>>
>> You likely do not have the proper sidetone source selected.
>> Go to the STL menu and set the parameter to about 30 - then tap DISPLAY
>> to toggle between U6-25 and U8-4. Stop when you hear sidetone and exit
>> the menu.
>>
>> 73,
>> Don W3FPR
>>
>> On 7/20/2020 3:50 PM, Christophe aufacf wrote:
>>> Good morning all ,
>>>
>>> I repaired my K2 with Don recently the problem now
>>>
>>> I realized that I can handle in Cw but I no longer have at the same
>>> time the sound of the CW of course in emission
>>>
>>> the STL 030 menu, whatever the level, nothing changes, any idea?
>>>
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
