Kirk,
You may have accidently gotten something sticky onto the keyer plug tip
which is now stuck inside the jack and making the contact resistance too
high - since you can insert dits, I suspect that increased resistance
somewhere in the dot circuit line is the most likely problem. Make some
more continuity checks to confirm where the problem is.
You can easily remove the left side panel to gain access to the 220 ohm
resistors (R1 and R2) in the dot and dash paddle lines and allow you to
check continuity from the paddle terminals to the inside of the K2. The
resistors are located on the edge of the RF board near the key jack. If
you find good continuity between the paddles and the resistors R1 and
R2, then the path through the jack is fine - check continuity to the
microprocessor pins (Control Board U6 pins 29 and 30) for the other half
of the path.
If there is no problem with the keyer jack or the plug to jack
connection, try re-seating the microprocessor in its socket - that will
clean the socket to pin connections which may help.
73,
Don W3FPR
Kirk Brown wrote:
> When I switched from straight key to my paddles, I found one side of the
> paddles would not work (in my case the dits). I checked the continuity of
> the paddles-to-plug and that's ok. I suspect the jack itself, but here's the
> strange part: I can make characters with dot insertion (G, Q, 9, etc.) but
> not characters that start with dots (E, 4, V, etc.). The reverse is true if
> I change from left to nor in the software. If I invert the paddle polarity,
> the opposite is true (dits and no dahs unless inserting). Any ideas?
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
