Login  Register

Re: K3 Caution when using an external monaural speaker

Posted by wayne burdick on Dec 20, 2008; 9:23am
URL: http://elecraft.85.s1.nabble.com/K3-Caution-when-using-an-external-monaural-speaker-tp1680829p1681294.html

Hi David,

Lyle, KK7P (who designed the KIO3 board set) will create an application
note and post it as soon as possible.

The short version is: put 1/8-W (or larger), 470-ohm resistors from
each speaker output to ground. (The actual value isn't critical;
anything from 330 to 1000 ohms would probably work just as well.) This
can be done conveniently on the KIO3's audio daughter board, at its
single-row, right-angle male connector.

Technical details:

The resistors hold the (-) leads of the AF amp's large electrolytic
coupling capacitors at ground potential (RF board, C2 and C3, 470 uF).
Thus if you accidentally ground *either* of the speaker outputs, you'll
be changing only the AC load to the amplifier -- not the DC voltage.
This means you won't get a big current spike backward, into the AF
amp's output, through the electrolytic; that's what we think can damage
the chip, because the caps can dump a lot of energy very quickly.

An astute observer would note that a similar current spike should be
generated on power-up, if a short at either speaker jack was present at
that time. But the AF amp chip protects itself during power-up,
limiting current at its output pins. If it didn't, even the presence of
a low-Z speaker might cause chip damage.

With the resistors in place, Lyle repeatedly shoved a mono plug into
the speaker jack, under both small and large-signal AF output
conditions. He couldn't break the amp chip.

Credit for this "bleeder resistor" idea goes to another one of our
staff engineers, Bob, N6CM. Lyle and I both wish we'd thought of it.

73,
Wayne
N6KR

On Dec 20, 2008, at 12:59 AM, David Cutter wrote:

> Wayne
>
> I will be doing all the mods for Christmas. Hope you can give us the
> info really soon so I don't have to take the K3 apart again.  Can you
> just point to the circuit and tell us what you intend ahead of the
> official mod instruction?
>
> 73
> David
> G3UNA
>>
> To this end, we're working
>> on a very simple modification to the KIO3 audio daughter board. This
>> will be the subject of a modification document soon, and is already
>> being phased into production.
>>
>> 73,
>> Wayne
>> N6KR
>
>

---

http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com