Re: Short TX burst when changing mode from Data to AM
Posted by
Joe Planisky on
Dec 28, 2008; 7:33pm
URL: http://elecraft.85.s1.nabble.com/Short-TX-burst-when-changing-mode-from-Data-to-AM-tp2019236p2019284.html
Hi Kari,
Yes, this was just reported and discussed a few days ago :-) See the
messages with the subject line "Transmit when switching from DATA to
AM mode?" starting Dec. 25, 2008. It has been reported to Elecraft.
Until it's fixed, one possible work around is to reduce VOX Gain when
not using VOX.
73
--
Joe KB8AP
On Dec 28, 2008, at 11:15 AM, Karza wrote:
> Hi,
>
> When I change mode of my K3 #310 from Data to AM
> using the "Mode <down>" -button, a short
> ( abt 1 second ) TX burst gets sent out.
> Burst power is roughly 1/5 of the requested
> output power.
>
> This happnens if VOX Gain is set to about 20 or
> higher and even when there are no mic-, data- or
> RS232-cables connected.
>
> I'm running MCU 2.76 with DSP 1.98
>
> Anyone else noticed this?
>
> 73's de Kari
> oh2gqc
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com