Re: front mic not working after subRx install
Posted by
Ian Maude on
Jan 13, 2009; 8:58am
URL: http://elecraft.85.s1.nabble.com/front-mic-not-working-after-subRx-install-tp2148544p2150276.html
Mike Scott wrote:
> I installed the second receiver in my K3 and at the same time made the
> prescribed audio and line out modifications.
>
> After checking out the receiver my microphone is now dead using the front
> panel. Rear connection works okay. I have been using the front panel
> microphone connector without a hitch up until the time I went off line to
> make the above modifications.
>
Did you have to add the resistor on the bottom of the RF board Mike? It
is easy to short across one of the tracks and stop the mic audio. I had
this problem with the first one I did. Fortunately the second one
didn't need the resistor :)
73 Ian
--
Ian J Maude, G0VGS
SysOp GB7MBC DX Cluster
Member RSGB, GQRP, FISTS
K2 #4044 |K3 #455
http://www.amateurradiotraining.org
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com