Login  Register

Re: KX1 Resistance checks

Posted by Don Wilhelm-4 on Mar 16, 2009; 8:34pm
URL: http://elecraft.85.s1.nabble.com/KX1-Resistance-checks-tp2488242p2488318.html

Ed,

KX1 U6 pin 3 is connected to ground, so you should have a very low
resistance reading.  The resistance chart on page 42 3rd item from the
bottom indicates that the reading should be less than 5 ohms.
It sounds like yours passes with flying colors.

I cannot comment correctly on the high resistance reading from your
particular DMM, but you may want to consult the instruction sheet for
that DMM.
Infinite resistance should appear the same as the reading wihich you
obtain with both probes out in thin air,  touching nothing.

73,
Don W3FPR

EMD wrote:

> Well I finished phase II and I have a problem with the resistance checks with
> U6. Pin 3 should be > 10k but I am reading .1 to .2 ohms.  The next thing on
> Pins 1 and 2 are showing 0.F M ohm which I think indicates infinite
> resistance so I think thats okay?  I checked for a cold solder joint and it
> looks good so I think U6 is dead.  If so how do you replace U6?
>
> 73,
> Ed  KE7HGA
>  
>  
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html