K3 and N1MM Logger Configuration Rosetta Stone

Posted by N0tk on Mar 17, 2009; 1:13am
URL: http://elecraft.85.s1.nabble.com/K3-and-N1MM-Logger-Configuration-Rosetta-Stone-tp2489303.html

I need some help from anyone who has successfully used their K3 and N1mm Logger connected through the computer serial Com1 port. With the K3 off and connection from the K3 RS232 connector to the computer Com1 port I select Config Ports and have the settings under the Hardware Tab as Always CW and Don't Change Radio Mode. Under the Hardware Tab I select K3 for Com1 with DTR(Pin4) and RTS(Pin7) both set to Always On as suggested by the N1MM information displayed. With the K3 mode set to CW and the K3 Config for RS232 is set to the default for the K3 I power on the K3 and I click OK for the N1MM Config window. The VFO A window bandmap shows the correct frequency displayed by the K3. Then I get a series of error messages that say Get Entry Window(RadioInterface_Interpret Response)-9-Subscript... which locks up the N1MM program. 
Seems like a configuration problem but may also be a problem with the K3 RS232 port.

Any constructive suggestions will be appreciated.

TKS

Dan N0TK
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html