Posted by
wayne burdick on
Apr 21, 2009; 9:15pm
URL: http://elecraft.85.s1.nabble.com/K3-beta-firmware-revision-3-11-now-available-tp2672594.html
K3 beta-test firmware revision 3.11 (with DSP rev. 2.15) is now
available. For details, see the release notes below.
Please send any problem reports to
[hidden email]. For
instructions on how to load beta firmware, please see:
http://www.elecraft.com/K3/k3_software.htmWe recommend that you use the latest revision of K3 Utility, which can
also be found on the K3 software page.
73,
Wayne
N6KR
* * *
MCU 3.11 / DSP 2.15 April 18, 2009
Misc. Improvements:
* DATA SUB-MODE NOW SAVED/RESTORED CORRECTLY: On power up and on some
band changes, the data sub-mode (e.g. FSK D) was getting lost.
* ERROR TONE PITCH PROBLEMS FIXED: The sidetone pitch was getting
changed by certain error conditions and when doing TUNE.
* SWITCH TONES NO LONGER GETTING STUCK ON: In AM mode with wide AM
bandwidths selected, tapping HI/WIDTH or LO/SHIFT could leave the
switch feedback tones on, or omit the second switch tone entirely.
* BALANCE CONTROL MOVEMENT JUST AFTER POWER-UP NOW OK: Someone noticed
that if you power up the rig with the sub turned on, then move BALANCE
(SUB AF) before moving AF GAIN, the main receiver AF would be lost
temporarily.
---
http://www.elecraft.com______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html