Re: How do I make my K3 go to HP (100 W)

Posted by Greg - AB7R on May 01, 2009; 3:42am
URL: http://elecraft.85.s1.nabble.com/How-do-I-make-my-K3-go-to-HP-100-W-tp2751118p2751595.html

Jim,
If you have the power set above 13W it will say HP.  Exit the menu and  
change the Power setting to below 13W and it will say LP.

73
Greg
AB7R

On Apr 30, 2009, at 6:00 PM, W3CP wrote:

> The K3 went to LP yesterday without me knowing it. I was surprised  
> that no
> one on the QCWA CW net could hear me until I finally looked at the  
> power
> meter.  When CONFIG TX GN is examined, it says LP but I don't find a  
> way to
> make it go to HP. If the PA has failed the K3 didn't tell me.
>
> I had planned on using the K3 for the 7th Call Area party tomorrow,  
> and I
> hope some one can help this over-the-hill operator understand how to  
> use
> this radio.
>
> 73,  Jim  w3cp
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html