Login  Register

Re: Case for noise generator

Posted by M0XDF on Aug 22, 2009; 7:11am
URL: http://elecraft.85.s1.nabble.com/Case-for-noise-generator-tp3490650p3494238.html

Good idea David and one I'll bear in mind, but you can't clamp like  
that into an Altoids tin, because it has a rolled lip, come to think  
of it, would a 1/2 hole go in the side? Great idea though Joe
73 de M0XDF, K3 #174
--
A society grows great when old men plant trees whose shade
they know they shall never sit in. -Greek proverb

On 22 Aug 2009, at 05:25, David Gilbert wrote:

>
> To cut a nice hole in almost anything (thin metal, plastic, leather,
> cloth, etc), TIGHTLY clamp a piece of smooth plywood or particle board
> (say 5/8 inch thick) on both sides of the material and just drill
> through the entire sandwich with a sharp drill bit.
>
> 73,
> Dave   AB7E

> Joe Planisky wrote:
>> If one has the equipment and skill to drill a 1/2 inch hole in very
>> thin sheet metal, the XG2 fits perfectly in an Altoids mint box.  
>> Take
>> the rubber feet off and put an old credit card in the bottom to
>> prevent the solder joints from shorting to the case.  The top pops
>> open for easy access to all the controls.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html