Posted by
Don Rasmussen on
Jun 27, 2008; 6:21pm
URL: http://elecraft.85.s1.nabble.com/Transmit-AM-through-FM-Filter-tp365954.html
As far as I know, the K3 filters are not intelligent,
the K3 has no way of knowing what the filter is other
than by your setup. If the FM filter was defined as a
5 khz filter, the K3 would probably send the signal
through it and the signal would probably be spectrally
purer than the vast majority of the gear that's being
used on AM today. But the only way to find out would
be to put it on a spectrum analyzer. Elecraft has
spoken of removing the firmware block at some point in
the future. There is also a block that keeps you from
transmitting out of band, which is annoying when
you're
connected to a dummy load.
[Elecraft] [K3] Transmit AM through FM Filter?
Lyle Johnson kk7p at wavecable.com
Fri Jun 27 13:13:42 EDT 2008
Previous message: [Elecraft] [K3] Transmit AM through
FM Filter?
> Checked the archives, but unable to find an answer.
If I was to purchase
> ONLY an FM filter, can I also TX AM through it
without issue?
The current firmware blocks the use of any foilter for
AM Tx other than
6 kHz.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com