Dumb(?) dummy load question
Posted by
Eric Ward-3 on
Jun 22, 2004; 2:32pm
URL: http://elecraft.85.s1.nabble.com/Dumb-dummy-load-question-tp368028.html
In an attempt to save pennies, I got a 10W 50 ohm resistor ($1.79 for two) at the Shack and soldered it to a male BNC--I figured this would make a serviceable QRP dummy load. The resistor checked out at 50.0 ohm on my DMM.
When I hooked this to my KX1 and went through the ATU alignment procedure (nulling C9, etc), I only get an apparent out put of about 0.3W (according to the display on the radio). Ditto when I tune my G5RV--I get to 1:1.1, but with only 0.3W. (This antenna/feedline system is tunable by my LDG Z100 to 1:1; see below.)
I had previously gone through the ATU alignment using, instead of a dummy load, the G5RV routed through the external match (the LDG Z100) tuned for that frequency. I figured that would be pretty close to 50 ohm, since it achieves an apparent 1:1 on that freq with my Icom 706 rig.
When I use the tuned G5RV as a "dummy load" and go through alignment, I get what appear to me more reasonable values--i.e. when I subsequently tune the same antenna with the KX1 ATU, I get 4.3W and SWR of 1:1.6.
So something funky is going on and I cannot figure it out. Is there some bloody obvious reason why the 10W resistor is not a good dummy load? Is something else wrong with my rig, which otherwise is nominal in all respects? (BTW, I have R4 maxed out clockwise.) I do not have a wattmeter, so I cannot independently check output with and without the ATU installed, but the rig is transmitting on 40 and 20m.
Thanks for any ideas...
73,
Eric
N0HHS
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
http://mailman.qth.net/mailman/listinfo/elecraftYou must subscribe to post.
Subscriber Info (Addr. Change, Unsub etc):
http://mailman.qth.net/subscribers.htmElecraft page:
http://www.elecraft.com