# 4472 new builder problem
Posted by
Jerry Deibel on
URL: http://elecraft.85.s1.nabble.com/4472-new-builder-problem-tp371113.html
Hi to all,
Just finished Part 2 of the basic K2 and having problems with the VCO Alignment. I set the K2 to 4 mhz and connected a DVM to the left side of R30 and I read 8.0 v and can not change it by adjusting L30. I checked the VCO readings and just 4000 and 7300 were on the high side.
How many turns can you turn L30? I only seem to get about 1 and 1 half down and i get resistance, don't want to break it.
The manual also says that if you do not get any change in the voltage ( like i have) to "refer to Troubleshooting". Well there is no mention of this in the troubleshooting section that I can find.
Any help would be appreciated.
Tnx in advance
Jerry , N2UZ
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com