Posted by
Don Wilhelm-3 on
Nov 02, 2004; 4:53am
URL: http://elecraft.85.s1.nabble.com/Signal-Generator-tp371279p371281.html
Steve,
If your 'scope will indicate down to 20 mv (I assume that is peak to peak),
you should be quite able to use the oscillator shown in the K2 manual - the
lowest expected voltage indicated in the manual is 0.27 Vrms at the 2nd
Crystal Filter Output and that is 756 millivolts peak to peak. In fact,
with a 'scope that sensitive, you could use a signal source of only
one-tenth the 140 mVrms value stated and achieve similar results.
73,
Don W3FPR
----- Original Message -----
Any suggestions or recommendations for a Sig Generator used for applications
such as tracing as described in Appendix E of manual or at elecraft's site.
I am aware of the simple oscillator with 10MHZ crystal that is described
after the Sig tracing section of appendix. I have found that the signal
generated for my scope 199C by fluke needs to be in the order of
20millivolts for the 10 to 1 probes. Any suggestions or "redirection" is
appreciated..hi..hi..
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com