Re: K2 Control Board Resistance Checks

Posted by Don Wilhelm-3 on
URL: http://elecraft.85.s1.nabble.com/K2-Control-Board-Resistance-Checks-tp371385p371386.html

Jeff,

The reading is a wee bit on the low side, BUT...
The proper answer depends on your DMM.  First try reversing the probes, and
try another DMM if you can obtain one (beg or borrow).

Bottom line - know your test instruments and their limitations - only then
can you know whether a problem exists or not.

73,
Don W3FPR

----- Original Message -----
>
> I have just completed the Control board on #3375 and have a question about
> the resistance checks.  Specifically the check on U4, OUT
>
> The manual says to look for 3-7 k at this pin ... and I measure 2.48 k
> with
> my DMM.  Is this value close enough?  Should I be looking for a problem to
> correct?
>


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com