Balun question
Posted by
Vic K2VCO on
Apr 06, 2005; 11:39pm
URL: http://elecraft.85.s1.nabble.com/Balun-question-tp376719.html
I made a simple 1:1 receive-only balun for 160 meters by winding 9 bifilar turns
of no. 24 enameled wire on an FT37-77 toroid. I connected a 50-ohm resistor to
the output and my MFJ antenna analyzer to the input. On 1.8 MHz it shows a
resistance of 50 ohms, an inductive reactance of 1 ohm, and an SWR of 1.0:1.
My question is, did I make a 'good' balun? Are there other tests I should do?
It's job will be to isolate a receiving loop antenna from its feedline, to keep
the nulls deep and reduce noise pickup.
The RANT feature of the K2's 160-meter option has made it possible for me to use
a ferrite loop which is only 21 inches (53.3 cm) long and has a s/n ratio much
better than my inverted L transmitting antenna, even without the balun. I'll
put details on my website after I finish testing it.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com