Re: AGC Alignment
Posted by
Paul Bruneau on
Apr 10, 2005; 12:47am
URL: http://elecraft.85.s1.nabble.com/AGC-Alignment-tp376809p376811.html
At least a few of us saw exactly the same thing in the last few weeks.
We never heard anyone giving grave warnings that we were in
trouble...so I don't know what to tell you, except that I'm in exactly
the same boat.
I planned on measuring it again when I get to the next alignment/test
where that board is powered up. For now I'm still winding toroids.
-Paul KB8NMZ
K2 #4818
On Apr 9, 2005, at 7:38 AM, Evert Bakker wrote:
> Hi all,
>
> I'm assembling the K2 here (SN 4836) and came to the first
> check/alignment. No smoke here so far, but when adjusting the setting
> for the AGC as described on page 47 I became suspicious about the
> alignment procedure. Adjust R1 for 3.80 V on the DMM. I turned R1 and
> reached the end and got stuck on 3.78V. The absolute value of 3.78
> doesn't worry me but that I ended up at the limit of the R1. I thought
> I should check all variables like DC voltage which should be 8V (was
> 7.98V so OK). Checked the resistors (mainly RP6 / 5.1K) and, RF gain
> potentiometer 5K and the R1 (50K). All looked fine. So what's wrong?
>
> I started making calculation on the resistor dividing network and came
> to the conclusion that the maximum voltage (theoretically) could be
> close to 3.82V when the RF-gain is fully CW (0 Ohm) and the R1 is
> set fully CCW (50K).
>
> I wonder if something is wrong here and if not, why was the alignement
> procerdure setup like this (it could heve been something like: Set
> RF-Gain full CW, R1 full CCW and check the voltage at pin 5 of U2 to
> be close to3.80V)? Or did I miss some errata info?
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com