Re: AGC Alignment
Posted by
Mark J. Schreiner on
Apr 09, 2005; 12:55pm
URL: http://elecraft.85.s1.nabble.com/AGC-Alignment-tp376809p376813.html
When recently building mine I had a similar problem. I moved my ground
connection to one of the small loops on the board and that was enough to
give me a higher reading and tweak R1 into range. Seems that the
"Ground" that I had picked wasn't as good of a ground as I thought!
There certainly may be another reason for your problem as well, but just
thought I would offer my experience. Hope it helps!
Mark, NK8Q
K2 #4786
Evert Bakker wrote:
> Hi all,
>
> I'm assembling the K2 here (SN 4836) and came to the first
> check/alignment. No smoke here so far, but when adjusting the setting
> for the AGC as described on page 47 I became suspicious about the
> alignment procedure. Adjust R1 for 3.80 V on the DMM. I turned R1 and
> reached the end and got stuck on 3.78V. The absolute value of 3.78
> doesn't worry me but that I ended up at the limit of the R1. I thought
> I should check all variables like DC voltage which should be 8V (was
> 7.98V so OK). Checked the resistors (mainly RP6 / 5.1K) and, RF gain
> potentiometer 5K and the R1 (50K). All looked fine. So what's wrong?
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com