Login  Register

Re: KPA100 power on 20m/30m, update

Posted by Stewart Baker on Jun 22, 2005; 5:19pm
URL: http://elecraft.85.s1.nabble.com/KPA100-power-on-20m-30m-update-tp379639p379640.html

I had problems with HI CUR on 14 & 18MHz,  3.6 and 3.7 Amps respectively.
Changing C80 & C81 cured the problem, and I now have 2.9 and 2.4 Amps drawn.

73
Stewart G3RXQ

On Wed, 22 Jun 2005 10:36:20 -0400, Mike Markowski wrote:

> This is a follow up to my own problem for the sake of complete Elecraft
>
> archives.  :-)
>
> A few weeks back I mentioned having slightly lower power on 30m.  When
> the power knob was at its max, I had 97 W while all other bands were
> close to 120 W.  What I forgot to mention is that on both 20 m and 30 m
> I always got the HI CUR warning, though the warning threshold was set to
> 3.5 A.
>
> I recalibrated the PA and then got 100+ W on 30 m.  But a subsequent
> check a week or so later showed I was back down to 95 W into a dummy
> load.  Not a big deal, really, but I didn't like the HI CUR message and
> spoke with Gary at Elecraft about it.  He recommended changing the C80 &
> C81 caps.  After doing so, I no longer get the HI CUR warning.  In
> addition, I get slightly over 100 W on all bands rather than the nearly
> 120 W on most.  Whether that it's due to new caps or better calibration,
> though, I don't know...  I posted this followup because initially it
> seemed that a simple recalibration took care of the issue, but turns out
> I needed new caps like the other guys who were suffering from even worse
> side effects of their C80 and C81!
>
> 73,
> Mike  AB3AP
> _______________________________________________
> Elecraft mailing list
> Post to: [hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com