Posted by
wayne burdick on
Aug 08, 2005; 5:48pm
URL: http://elecraft.85.s1.nabble.com/Re-Elecrafts-T-1-tp381070p381087.html
On Aug 8, 2005, at 9:29 AM, Bob Cunnings wrote:
> So far I've not bothered with a balun when running my KX1 into a
> dipole fed with balanced line (using the internal tuner to match) and
> seem to have pretty good results, better than the random wire and
> counterpoise so far (portable operation over poor ground). My thinking
> was that since the whole system is floating with respect to ground
> (I'm usually sitting on a slab of rock), it wouldn't really matter.
Bob,
Operating in this "floating" mode without a balun may be satisfactory
in many cases. But a balun should be helpful with antennas that present
a high impedance to the tuner, for two reasons: (1) it steps the
impedance down by a factor of 4, which may help if the tuner's range is
limited; (2) it reduces the RF voltage appearing on the chassis. The
latter is more of an issue at higher power and in SSB mode, where it
might prevent "hot mic" syndrome.
73,
Wayne
N6KR
---
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com