Posted by
wayne burdick on
Aug 08, 2005; 7:16pm
URL: http://elecraft.85.s1.nabble.com/Re-Elecrafts-T-1-tp381070p381091.html
Darrell,
My comment about heating was in regards to saturation, which greatly
increases loss. At QRP levels a BL-1 will never saturate, even if it is
working into a very low or high impedance. OTOH, at high power, a
severe mismatch really *will* heat up the balun, and if it saturates,
it will become a lot less efficient, making losses much greater.
You're correct that efficiency of impedance transformation is the same
at any power level -- as long as the balun isn't in saturation.
73,
Wayne
On Aug 8, 2005, at 10:57 AM, Darrell Bellerive wrote:
> On August 8, 2005 10:29 am, wayne burdick wrote:
>> at QRP levels, a large balun such
>> as the BL1 should have negligible heating loss over a very wide
>> impedance range.
>
> I would have thought that the heating is a result of inefficiency. The
> heat is
> lower at QRP levels than at higher power levels since there is less
> power to
> produce heat. If a balun is converting 10% of energy into heat, then
> more
> heat is produced with 100 watts than 5 watts, but the loss is still
> the same
> 10%. Am I wrong?
>
---
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com