Posted by
Howard W. Ashcraft on
Aug 25, 2005; 5:48pm
URL: http://elecraft.85.s1.nabble.com/KX1-S-meter-calibration-tp381522p381523.html
I believe the S9 "standard" is 50 millivolts, which is 50 microwatts at
50 ohms [v**/50], which is -13 dbm [10*log(50uw/1mw)]. So, I would say
that +7 dbm would be your level. As always, check the math and the
logic. (I'm sure someone on the reflector will spot an error.)
-----Original Message-----
From: Mike and Alicia Fanning [mailto:
[hidden email]]
Sent: Wednesday, August 24, 2005 7:07 PM
To:
[hidden email]
Subject: [Elecraft] KX1 S meter calibration
I'm trying to calibrate the S meter on my newly finished KX1 by cheating
and using a good signal generator at work during my lunch break. The
KX1 manual suggests using another receiver tuned to a strong (S9+20 dB)
signal as the "reference standard", and then setting the KX1 S meter to
full scale (6
bars) using this same signal as a reference. What level should I set my
sig gen to to generate an S9+20 dB signal level? I realize it's a
relative thing, but I don't want to put too much signal into the radio
and burn up the front end.
Thanks!
Mike, K4GU
*****************************
This communication, including any attachments, is confidential and may be protected by privilege. If you are not the intended recipient, any use, dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please immediately notify the sender by telephone or email, and permanently delete all copies, electronic or other, you may have.
To ensure compliance with requirements imposed by the IRS, we inform you that any tax advice contained in this communication (including any attachments) was not intended or written to be used, and cannot be used, for the purpose of (i) avoiding penalties under the Internal Revenue Code or (ii) promoting, marketing or recommending to another party any transaction or matter addressed herein.
The foregoing applies even if this notice is imbedded in a message that is forwarded or attached.
*****************************
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com