Posted by
jferg977 on
Feb 22, 2006; 2:19pm
URL: http://elecraft.85.s1.nabble.com/Re-K2-Power-Callibration-tp386863.html
From: "Don Wilhelm" <
[hidden email]>
Subject: RE: [Elecraft] K2 Power Calibration
To: "Cathy James" <
[hidden email]>, <
[hidden email]>
Message-ID: <
[hidden email]>
Content-Type: text/plain; charset="iso-8859-1"
""Adding either the KAT2, KPA100 or KAT100 options will include a proper
wattmeter in the K2 system and the display will indicate the proper
power
(if the wattmeter is calibrated properly), but the basic K2 uses only
an RF
Probe type detector and reports the 'power' based on the assumption
that the
load is 50 ohms non-reactive. Try a dummy load and if you see a major
discrepancy, you can blame the interconnecting coax or the wattmeter -
the
basic K2 power indication is quite correct when the laod is a 50 ohm
proper
dummy load.
73,
Don W3FPR""
Don, I attribute a fair amount of the convulsions involved in getting
my K2 callibrated to an inaccurate wattmeter. It came on the manual
tuner I bought. I fed a 50 ohm dummy load through the tuner with it
set to "bypass" I got readings on the wattmeter much higher than
those that I was actually putting out as we ascertained when we later
used a good wattmeter.
I think this speaks somewhat to assumptions about what the k2 builder
will already have or purchase for the project. I already had a good
DMM which agrees in the areas we checked with a really good Fluke - no
fluke apparently. The manual for the KPA100 suggest you may have
problems if you callibrate with a bad wattmeter. Soooooo, if you can
use the rf probe which you build with the k2 kit and a DMM, why not
suggest this as an alternative method to anyone who suspects his
wattmeter is not good or (gasp) doesn't have one? Or am I all confused.
Incidently 5087 works so well, I can't believe the range I get both in
and out on ssb 20, 40 & 80- meters with just the 23 foot whip. 73,
John KI4NGH
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com