Re: Coax Switch between two rigs
Posted by
Bob Nielsen on
Mar 01, 2006; 2:18pm
URL: http://elecraft.85.s1.nabble.com/Coax-Switch-between-two-rigs-tp387104p387105.html
On Mar 1, 2006, at 6:06 AM, Lee Buller wrote:
>
> OK....I know that this might be a dumb questions, but before I do
> a dumb thing I want to ask the question. I have two rigs...one of
> which is the K2/100. I have a two position coaxial switch (I think
> it is a Diawa CX201A) that I picked up at a hamfest. Is there
> enough isolation between the two positions where I could switch
> between two rigs? I don't want to blow out the front end of either
> rig. I would think that if you are using one rig, the other rig
> shouldn't be on or if it is on should not be on the same band.
> Again, would this be something stupid to do or is it something that
> is done routinely?
>
> Lee- K0WA
I am not familiar with the Daiwa switch, but the ones I use (Alpha-
Delta and MFJ) ground the unused sections and the isolation is quite
good.
Bob, N7XY
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com