Posted by
Don Wilhelm-3 on
URL: http://elecraft.85.s1.nabble.com/K2-deaf-tp387609p387610.html
Cary,
I don't have any really good ideas about what may be wrong (other than to
simply say "its broke" <G>), but I suggest that you turn the manual to
Appendix E and follow the steps outlined in the Receiver Signal Tracing
section.
As another alternative, you can try the "Cheap and Dirty Signal Tracing"
that Tom Hammond has advocated - the document is on the Elecraft website
under Builder Resources - then look at Troubleshooting Tips.
Once you localize the area of failure, we can help further in isolating it
to the failing component.
73,
Don W3FPR
> -----Original Message-----
>
> K2 #5266 was playing beautifully on cw and I aligned the filters last
> night for SSB, had no problems with that alignment. When I finished, I
> found my K2 deaf on ALL bands (it transmits just fine!)...The RANT is
> OFF, I have good tone with the SPOT feature (yes, I went through the
> troubleshooting steps), even went so far as to do a reset...nothing
> restored my K2's ears. Oh, yes, the antenna jack is connected to the
> 135' dipole and not the dummy load.
>
> I'm hoping its something really simple but at this point (actually at
> 1:30am), I'm mighty frustrated.
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com