RE: K2 power control
Posted by
Don Wilhelm-3 on
Jun 04, 2006; 3:30am
URL: http://elecraft.85.s1.nabble.com/K2-power-control-tp390511p390512.html
Joerg,
You either have something wrong with the wattmeter in the KPA100 or have
something wrong in the path from the wattmeter forward power circuit to the
VRFDET output from the KPA100.
During a quick keydown period (with only the base K2 powered or with the PA
turned off in the menu), check the following points on the KPA100 (in
order)to determine at which point the voltage disappears - these should all
be DC voltages - you should expect about 4 volts when the base K2 is
developing 10 watts or more:
U5 pin 5
U5 pin 7
U6 pin 3
U6 pin 6
U6 pin 6 is the KKPA100 output signal for the VRFDET line, and if you have
voltage to that point, look for an open in the ribbon cable (pin 10).
73,
Don W3FPR
> -----Original Message-----
>
> I need some help. I can not adjust my power anymore when K2 is
> connected to the 100 W PA. The PA is overloaded and power
> meter shows 200 watt !!!
>
> I tried to switch off PA in menu, but in this ca=e it is still
> running with maximum QRP power.
>
> I assume something goes wrong with VRFDET.
>
> If I disconnect th= PA from K2 power adjustment works fine.
>
> How could I investigate to find the reason for this fault ?
>
> 73 de Joerg (DL3QQ)
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com