Re: K2 signal tracing question

Posted by David Woolley (E.L) on Nov 05, 2009; 8:29am
URL: http://elecraft.85.s1.nabble.com/K2-signal-tracing-question-tp3948589p3950882.html

Paul Fletcher wrote:

> into saturation. I'm only measuring 4.9V on pin 1 of U2 which seems way low
> compared to the spec. Is this enough input as the spec is 145mV RMS from a

Where are you getting the specification from?  The K2 doesn't operate
the IF amplifier at the Vcc value given in its data sheet and the AGC
operation scales with supply voltage.

> RF probe (which I don't have - I'm using a scope). Initial checks haven't
> shown up anything significant but I will start from scratch again tomorrow
> as this week has been lost repairing my scope.
>

--
David Woolley
"we do not overly restrict the subject matter on the list, and we
encourage postings on a wide range of amateur radio related topics"
List Guidelines <http://www.elecraft.com/elecraft_list_guidelines.htm>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html