BL-2 Balun Heating
Posted by
Gary Winkelman on
Nov 20, 2009; 3:02am
URL: http://elecraft.85.s1.nabble.com/BL-2-Balun-Heating-tp4035832.html
I recently built a BL-2 Balun. It is connected between my Palstar AT1KM
tuner and my doublet antenna. The antenna consists of a 100' wire up
25' and fed by 95' of 600 ohm open wire feeder. I'm using the 1:1
setting on the balun. There is a 4" section of RG-213 between the balun
and a coax input of the tuner. I'm driving it with 125 watts from a
TS-850. After no more than a few minutes of CW or RTTY transmission,
the balun is too hot to touch, the SWR rises and the power goes down.
The balun is obviously saturated.
Does anyone have an idea how I can reduce the overheating? I've tried
adding a heat sink but it doesn't make any difference.
Tnx for reading!
Gary N2UM
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html