Re: [Elecraft] Help with K3 ports for CW Skimmer CAT
Posted by
Larry, VE3LR on
Dec 11, 2009; 5:58pm
URL: http://elecraft.85.s1.nabble.com/Help-with-K3-ports-for-CW-Skimmer-CAT-tp4151121p4152714.html
Thanks for the reply Julian (I am a frequent
visitor to your site so I feel like I already know you!).....for some reason the
moderator bounced my posting saying I wasn't registered, which I am.
Anyhow, I am curious if you know the answer to
this.......I have HRD shut down, would this still affect CW Skimmer's ability to
"perform" CAT?
Thanks, Larry
----- Original Message -----
Sent: Friday, December 11, 2009 10:19
AM
Subject: Re: [Elecraft] Help with K3
ports for CW Skimmer CAT
Larry, VE3LR wrote:
As we age the brain (or at least mine) gets
confused so easy......the love of my life (my K3) works flawlessly in CAT
with HRD using Elecraft's serial/USB cable. CW Skimmer also works flawlessly
(using 3KHZ mode) but I cannot get the CAT side of CW Skimmer to cooperate.
No, it's just a plot by computers to make us think
we're getting senile. CW Skimmer should work using the same settings (COM port
and baud rate) you use for HRD (but not at the same time as HRD is running,
unless you're using LP-Bridge or a serial port splitter.) I was going to tell
you the settings I used but the trial has expired and I'm darned if I'll pay
$75 for a program I only use to test its integration with KComm.
If
you're sure the settings are the same as HRD's then it could be that you have
a USB to serial adapter that works with some programs and not others - it's
quite a common problem. If you search back through the archives you'll find
many recommendations for ones that work - my vote is for anything with an FTDI
chipset.
Actually, using LP-Bridge might help, as then it will be
LP-Bridge talking to the K3 and Skimmer will be talking to 'Bridge, and I
haven't seen too many reports of LP-Bridge having trouble with USB adapters.